Introduction to a cutting Fluid

Cutting Fluid
Cutting fluid is a type of coolant and lubricant designed specifically for metalworking processes, such as machining and stamping. There are various kinds of cutting fluids, which include oils, oil-water emulsions, pastes, gels, aerosols (mists), and air or other gases. They may be made from petroleum distillates, animal fats, plant oils, water and air, or other raw ingredients. Depending on context and on which type of cutting fluid is being considered, it may be referred to as cutting fluid, cutting oil, cutting compound, coolant, or lubricant.
Most metalworking and machining processes can benefit from the use of cutting fluid, depending on workpiece material. Common exceptions to this are cast iron and brass, which may be machined dry (though this is not true of all brasses, and any machining of brass will likely benefit from the presence of a cutting fluid)

Comments

Post a Comment

Popular posts from this blog

Operations Performs on Lathe Machine

Image
Facing Facing is the process of removing metal from the end of a workpiece to produce a flat surface. Most often, the workpiece is cylindrical, but by using 4- jaw chuck we can face rectangular or odd-shaped work to form cubes and other non-cylindrical shapes. When a lathe cutting tool removes metal it applies considerable tangential (i.e. lateral or sideways) force to the workpiece. To safely perform a facing operation the end of the workpiece must be positioned close to the jaws of the chuck. The workpiece should not extend more than 2-3 times its diameter from the chuck jaws unless a steady rest is used to support the free end. Straight turning In this operation the work is held in the spindle and is rotated whole the tool is fed past the work piece in a direction parallel to the axis of rotation. The surface generated is a cylindrical surface. Taper Turning A taper may be defined as a uniform increase or decrease in diameter of a work piece measured along its length...
Read more

Tool Holding Devices in Drill Machine

Image
Tool-Holding Devices: Drill press spindle provides means of holding and driving cutting tool.End may be tapered or threaded for mounting drill chuck. Most common devices are used in Drill presses:       Drill chucks       Drill sleeves        Drill sockets Drill Chucks: Most common devices used for holding straight-shank cutting tools. Most contain three jaws that move simultaneously when outer sleeve turned. Hold straight shank of cutting tool securely. Two common types               Key   Keyless     Drill sleeves:                        Used to adapt cutting tool shank to machine spindle if taper on tool is smaller than tapered hole in spindle   Drill sockets: ...
Read more

Parts of Vertical Milling Machine

Image
Parts of Vertical Milling Machine The vertical knee mill is the most common milling machine found in machine shops today. Therefore it will be used as an example to describe the general parts of all mills. Head                The head (drive) is that part of the drive system that transforms electrical power from a motor to mechanical power in the spindle. The drive system also allows the machinist to change the speed of the spindle (RPM) and therefore the cutting tool. The quill moves vertically in the head and contains the spindle in which cutting tools are installed. Column                The column is the most important part which is mounted on the base and acts as a support and holding device for all the other parts of a milling machine. It acts as a support for table and all feed mechanisms. The column should be rigid enough to sust...
Read more